GARAGE DOOR OPENER REPAIR IN HAYWARD, CA
When a garage door opener in Hayward stops working, it is usually one worn part, not the whole unit. 911 Garage Doors and Gates repairs openers all over Hayward, and most repairs are done in one visit because our trucks carry the common gears, logic boards and safety sensors.
We fix LiftMaster, Chamberlain, Genie, Craftsman, Ryobi, Marantec, Overhead Door, Linear, Wayne Dalton, Guardian and most other brands. Opener work in Hayward runs $125 to $900, depending on whether it is a repair or a full replacement, and you get the exact price before any work starts.
- Opener repair and maintenance
- Stripped gears and broken chains
- Doors that reverse or won't close
- Remotes that stopped working
- Logic board replacement
- Motor replacement
- New opener installation
- Licensed CSLB #1098597, insured and bonded
If the opener hums but the door will not move, check the spring first: an opener cannot lift a door with a broken spring. See garage door spring replacement in Hayward.
Call 510-458-2048 for a free quote.
GEARS AND CHAINS
Grinding noises, a motor that runs while the door stays put, or a chain hanging loose from the rail usually point to the drive. The gear and sprocket assembly inside many chain and belt openers wears out over time, and we replace it with quality parts so the opener runs smoothly again.
We also repair chains that broke or came off the rail.
SAFETY SENSORS
The two safety sensors near the floor make the door reverse if something is in its way. When they are out of line, dirty or damaged, the door may refuse to close, reverse on the way down, or close only while you hold the wall button.
Often the fix is simply lining them up again, and our LiftMaster safety sensor alignment video shows how. If that does not work, we test the sensors and wiring and replace what has failed.
LOGIC BOARDS AND MOTORS
The logic board is the opener's brain. A failing board can make the opener work only some of the time, ignore the remote, or stop partway for no clear reason. Motors wear out too, leaving the door slow and struggling.
Many LiftMaster and Chamberlain openers flash an error code on the unit, and that code tells us a lot before we even arrive. The common LiftMaster codes are listed on our main garage door opener repair page.
We find the fault first, then replace the board or the motor, or tell you honestly when a new opener makes more sense than another repair.
NEW GARAGE DOOR OPENERS
When an opener is worn out, we supply and install a new one. See the models we install on our new LiftMaster garage door openers page.
Print our $50 off new garage door opener coupon. It is valid on new opener installation over $250 and cannot be combined with other coupons or discounts.
Call 510-458-2048 for your free quote.
HAYWARD OPENER REPAIR QUESTIONS
Why won't my garage door close all the way?
Most often the safety sensors near the floor are out of line or blocked, so the opener sends the door back up. Check that nothing is in the way and that the two sensors face each other. If it still reverses, call us.
My opener runs but the door does not move. What is wrong?
Usually a stripped drive gear, or a chain that broke or came off. It can also be a broken spring, since an opener cannot lift a door without one.
Which opener brands do you repair?
LiftMaster, Chamberlain, Genie, Craftsman, Ryobi, Marantec, Overhead Door, Linear, Wayne Dalton, Guardian and most others. Our trucks carry common gears, boards and sensors, so most repairs are done in one visit.
How much does opener repair cost in Hayward?
Opener work in Hayward runs $125 to $900, depending on whether it is a repair or a full replacement. You get the exact price before any work starts.
How fast can you get to me in Hayward?
Same day for nearly all of Hayward. We are at 1019 Central Blvd, where I-880 and I-580 split, so a technician is often less than two hours away.
Are you licensed and insured?
Yes. 911 Garage Doors holds CSLB license #1098597 and is fully insured and bonded.